hi everyone, i have two questions for AD7266
question1:
in the datasheet of AD7266, it mentioned in "product highlight" that :The AD7266 offers both a standard 0 V to VREF input range and a 2 × VREF input range
so, in the case of vdd=3.3V, use internal 2.5V REF input range is configed to 2 × VREF, can the ADC provide a 0~3.3V input voltage convert range?
in my design, i have a 0.3~3.0V analog voltage needs to be converted, but the PCB board only have 3.3V VDD, so i can not use ADC that needs 5V VDD.
question2:
the datasheet mentioned the input range:,in pseudo differential mode "The AD7266 can have a total of six pseudo differential pairs. In this mode, VIN+ is connected to the signal source that must have an amplitude of VREF (or 2 × VREF, depending on the range chosen) to make use of the full dynamic range of the part."
does it be ok if i have a Vin-=1.25V and VIN+ has a commone voltage 1.25V and 0.7V amplitude? VIN+ range is 1.95~0.55. will this affect the accuracy of the ADC?(since the datasheet says "must have an amplitude of VREF (or 2 × VREF, depending on the range chosen) to make use of the full dynamic range of the part")
thank you!