ADIS 16210 /PCBZ interfacing with ARDUINO UNO.

Hi,

I need help on the following questions regarding ADIS16210/PCBZ. Any help regarding the same will be appreciated.

1. What is the pin layout(numbering) of the J1 connector on the breakout board of ADIS 16210 ?

2. What is the pin configuration(which pin represents what) of the J1 connector on the breakout board ?

3. How do I interface this breakout board alone without any Eval board with the Arduino UNO ?

Note: I did not find much in the datasheets about the pin layout. I do not want to risk the sensor by assuming that it is the same as the other series of sensors.

Thanks in advance.

Shrims