I'm referring to this post http://ez.analog.com/message/32330#32330
about "grown" blocks addressing and i'm facing the same problem.
In detail, i would have the addresses of a grown simple block, in my
case a linear gain, contiguous in order to have my inter-processor
communications more efficient.
But on my, quite large, project i see that, at least in one case, i see
that this is not respected: i have the addresses of a gain block one
at location 442, one at location 444.
In the post i attached, Brett said that grown blocks should have
contiguous addresses, but i'm guessing that this is not a fixed rule.
Isn't it?
If so, will i have to modify all sigma-dsp writes in order to transfer all
grown blocks parameters independently as they were belonging to different blocks ?
May AD try to optimize their sigma-studio compiler in order to achieve this ?
Thanks
Tom